Yamaha RX-V571 Owner's Manual page 78

SET
RECEIVER
You can operate an external device such as a TV or BD/DVD player
with the remote control of the unit by setting the remote control code
for the external device (remote control code).
• External devices that do not support infrared remote control cannot be used.
• Confirm that the remote control ID is set to "IDI" on the external device. If another
remote control ID is set on the external device, the remote control does not work
correctly even if the remote control codes for the external device are registered on
the remote control.
• Leaving exhausted batteries in the remote control for more than 2 minutes, may
clear the registered remote control codes. If this should occur, replace the
batteries with new ones, and set the remote control codes.
• When the external device cannot be operated with the remote control even if all
corresponding remote control codes are set to the remote control, the external
device is net supported.
• The manufacturers and external devices that do not exit in "Remote Control Code
Search" contained in the CD-ROM are not available for operations of the unit's
remote control.
• Remote control code of an external device cannot be set from the name or model
number of a unit.
When the HDMI control functions of both unit and the playback
device are enabled, the devices may be controlled using the
remote control even if not registering the remote control code.
Registering remote control codes for TV
operations
Register a TV remote control code to control the TV with the remote
control.
• When the audio output jack on the TV is connected to the input jack on the unit,
follow the procedure in 'Registering remote control codes for external device
operations" (p.79) to register a TV remote control code.
2
3
4
Use "Remote Control Code Search" in the CD-ROM
to search the available remote control codes from
the category or manufacturer of the TV.
Press CODE SET using a pointed object such as the
tip of a ballpoint pen.
SOURCE/RECEIVERblinks twice.
Perform each of the following steps within 1 minute. Settings
will be automatically stopped if more than 1 minute passes
after the last operation. To reset, repeat from step 2.
Press TV _.
Enter a remote control code (4-digit) using the
numeric keys.
Once the remote control code is registered successfully
SOURCE/RECEIVER will blink twice.
If the registration fails, SOURCE/RECEIVER blinks six times.
En
78