Yamaha RX-V571 Owner's Manual page 41

TUNER
FM
AM
When tuning a radio, select a frequency or a registered station.
• To tune into the radio station, connect the antenna in advance (p.27).
• When the radio cannot get good reception, adjust the orientation of the antenna.
• FM/AM tuner frequencies will differ depending on the country or region where
the unit is being used. The explanation of this section uses a display with
frequencies used in U.K. and Europe models.
Changing FM/AM tuner frequency steps
(Asia and General models only)
The factory pre-set FM/AM tuner frequency steps are 9 kHz for AM
and 50 kHz for FM. Carry out the following settings and select the
frequency steps suitable for your listening environment.
2
Switch this unit to the standby mode.
Press _ while pressing and holding STRAIGHT on
the front panel.
Release the keys when "ADVANCED SETUP" (p.76) is
displayed on the front display.
After approximately a few seconds, the top menu items are
displayed.
Press STRAIGHT repeatedly to select one of the
frequency steps.
Switch this unit to the standby mode, and then
switch it on again.
The power turns on, with the settings you made configured.
Selecting a frequency for reception
2
3
Press TUNER to select "TUNER" as the input
source.
Press FM or AM to select FM or AM to receive.
Select the frequency with the following keys.
TUNING: Selects a frequency.
Press and hold this key for approximately a second to search
for a station automatically.
Numeric keys: Enter a frequency directly with numbers (For
example, press "9," "8," "5" and "0" to select a station on
98.50 MHz.).
• "Wrong Station!" appears when a frequency is out of receivable range.
3
STRAIGHT
Press PROGRAM L> repeatedly to display "TU."
PROGRAM <:s / D
"TUNED" lights up when a broadcast is received from a
station.
"STEREO" lights up when stereo broadcast is received from a
station.
En
41