Yamaha RX-V571 Owner's Manual page 30

Optimizing the speaker settings automatically (YPAO)
Starting the measurement
Start the measurement by following these steps.
2
Confirm that "Save / Exit" is selected and then press
ENTER.
SETUP
ENTER
RETURN
• YPAO measurement is not performed correctly when any obstacles are in the
room.
• While measuring, keep stuff in the corners or remove it from the room. It takes
approximately 3 minutes to finish this measurement.
Confirm that "Start" is selected, and then press
SETUP.
The measurement starts in 10 seconds. Press ENTER if you
want to start the measurement immediately.
• To cancel the measurement, press RETURN to stop temporarily, press
ENTER, select "EXIT" and then press ENTER.
• To retry the measurement from the temporary stop, select "RETRY" and then
press ENTER.
The following screen appears on the TV when the
measurement finishes.
• To confirm the measurement result, select "Result." For details, refer to the
"Confirming the measurement result" (p.31).
Confirm that "SAVE" is selected, and then press the
ENTER.
• To finish the measurement without saving the result, press the cursor keys to
select "CANCEU' and then press ENTER.
• If an error message (such as "E-1:No Front SP") or a warning message
(such as "W-1 :Out of Phase") appears, refer to "Error messages" or
"Warning messages" (p.32, 33).
Remove the YPAO microphone.
All settings for the speakers have been completed.
CAU'TIION
• The YPAO microphone is sensitive to heat. Protect YPAO microphone from
high temperatures (such as near AV equipment) and direct sunlight.
En
30