Yamaha RX-V571 Owner's Manual page 67

Equalizer
Selects an equalizer type.
"YPAO:Flat," "YPAO:Front" and "YPAO:Natural" can be set after performing YPAO.
Settings
Through (Default) Disables the equalizer.
Uses the graphic equalizer to adjust sound quality manually. For details,
Graphic EQ refer to "Adjusting the graphic equalizer."
YPAO:Flat Sets uniform characteristics for each speaker.
YPAO:Front Sets the characteristics of each speaker to match the front speakers.
YPAO:Natural Adjusts all speaker sound to give natural acoustics.
Adjusting the graphic equalizer
1 Select "Graphic EQ" in "Equalizer," and then press ENTER.
2 Press the cursor keys (A/V) to select a speaker to adjust, and then press ENTER.
3 Press the cursor keys (<_/_) to select a frequency you want to adjust.
Choices
63 Hz/160 Hz/400 Hz/1,0 kHz/2,5 kHz/6,3 kHz/16,0 kHz
_ Press the cursor keys (A/V) to adjust the volume.
Setting range
-6.0 dB to +6.0 dB (0.5 dB increments)
Default setting
0,0 dB
5 Use the cursor keys (<_/_>) and select "EXIT," and then press ENTER to finish
"Equalizer."
Test Tone
Turns the test tone generator on or off. When this setting is set to "On," the volume
balance settings for each speaker can be adjusted while listening to the output sound in
other speaker settings (such as "Level" or "Graphic EQ").
Settings
Off (Default) Does not generate test tones.
Generates test tones. While "On" is selected, test tones are produced
On
constantly.
• Repeat steps 3-4 to adjust the tone to your liking.
• Press RETURN or the cursor keys (<_/_) repeatedly to return to select a speaker to be adjusted
(step 2).
En
67