Yamaha RX-V571 Owner's Manual page 60

Tone Control
Adjusts the balance of the high-frequency range (Treble) and low-frequency range
(Bass) of sounds output from the front speakers. When headphones are connected,
adjusts the balance of the high-frequency range and low-frequency range of sounds
output from headphones.
Input sources
All (the setting is applied to all input sources)
Choices
High frequency range (Treble),Low-frequency range (Bass)
Setting range
-6.0 dB to + 6.0 dB (0.5 dB increments)
Default setting
Bypass (0.0 dB)
• When you set the balance extremely off, sounds may not match those from other channels well.
The tone control can also be adjusted with the keys on the front panel (p.7).
(_ Press TONE CONTROL to select "Treble" or "Bass."
(_) Press PROGRAM to adjust the setting.
Adaptive DRC
Sets whether dynamic range (from maximum to minimum) is adjusted automatically in
conjunction with adjusting the volume level.
When it is set to "On," it is useful for listening to playback at low volume at night.
Input sources
All (the setting is applied to all input sources)
Settings
Off (Default) Does not adjust the dynamic range automatically
On Adjusts the dynamic range automatically
When it is set to "On," the dynamic range becomes narrow at a low level volume, and
becomes wide at a high level volume.
off
Input Level Input Level
Volume: low Volume: high
Enhancer
Enables/disables Compressed Music Enhancer (p.40).
Input sources
All (the setting is applied to each input source)
Settings
Off Turns off the Compressed Music Enhancer mode.
On Turns on the Compressed Music Enhancer mode.
• Compressed Music Enhancer can be enabled/disabled with ENHANCER on the remote control as well.
Volume Trim
Corrects the volume differences between each input source. Adjust the parameter to
reduce any change in volume when switching between input sources.
Input sources
All (the setting is applied to each input source)
• Adjusted value is separately applied to the selected input.
Setting range
-6.0 dB to 6.0 dB (0.5 dB increments)
Default setting
0,0 dB
En
60