Ethernet.connection; Default Address - Extron electronics MVX Plus 128 VGA A User Manual

Ethernet Connection
Ethernet Link
The rear panel Ethernet connector on the
MVX Plus 128 VGA A switcher can be connected to an
Ethernet LAN or WAN. This connection makes SIS control
of the switcher possible using a computer connected to the
same LAN.
Ethernet connection
The Ethernet cable can be terminated as a straight-through cable or a crossover
cable and must be properly terminated for your application (figure A-1).
• Crossover cable — Direct connection between the computer and the
• Patch (straight-through) cable — Connection of the MVX Plus 128 VGA A
Figure A-1 — RJ-45 connector pinout tables

Default address

To access the MVX Plus 128 VGA A switcher via the LAN port, you need the
switcher's IP address. If the address has been changed to an address comprised of
words and characters, you can determine the actual numeric IP address using the
Ping utility. If the address has not been changed, the factory-specified default is
192.168.254.254.
Ping can also be used to test the Ethernet link to the MVX Plus 128 VGA A switcher.
A-2 MVX Plus 128 VGA A Matrix Switcher • Ethernet Connection
MVX Plus VGA A switcher.
switcher to an Ethernet LAN.
Side Clip Down
Pins 1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1&2 7&8
3&6 4&5
Patch (straight) cable
Side 1
Pin Wire color
1 White-orange
2 Orange
RJ-45
3 White-green
connector
4 Blue
5 White-blue
6 Green
7 White-brown
8 Brown
Crossover cable
Side 1
Pin Wire color
1 White-orange
Twisted
2 Orange
Pairs
3 White-green
4 Blue
5 White-blue
6 Green
7 White-brown
8 Brown
Side 2
Pin Wire color
1 White-orange
2 Orange
3 White-green
4 Blue
5 White-blue
6 Green
7 White-brown
8 Brown
Side 2
Pin Wire color
1 White-green
2 Green
3 White-orange
4 Blue
5 White-blue
6 Orange
7 White-brown
8 Brown