Ethernet Link; Ethernet.connection; Default Ip Addresses - Extron electronics MVX Plus 128 VGA A User Manual

Programmer's Guide, cont'd

Ethernet Link

The rear panel Ethernet connector on the switcher can be connected to an Ethernet
LAN or WAN. This connection makes SIS control of the switcher possible using a
computer connected to the same LAN or WAN.
Ethernet connection
The Ethernet cable can be terminated as a straight-through cable or a crossover
cable and must be properly terminated for your application (figure 4-3).
• Crossover cable — Direct connection between the computer and the
• Patch (straight-through) cable — Connection of the MVX Plus 128 switcher
Figure 4-3 — RJ-45 Ethernet connector pin assignments

Default IP addresses

To access the MVX Plus 128 switcher via the LAN port, you need the Extron
IP address, and may need the subnet mask and the gateway address. If the IP
address has been changed to an address comprised of words and characters, you
can determine the actual numeric IP address using the ping (ICMP) utility (see
appendix A, "Ethernet Connection", for more details). If the addresses have not
been changed, the factory-specified defaults are:
• IP address
• Gateway address 0.0.0.0
4-4 MVX Plus 128 VGA A Matrix Switcher • Programmer's Guide
MVX Plus 128 switcher.
to an Ethernet LAN.
Side Clip Down
Pins 1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1&2 7&8
3&6 4&5
192.168.254.254
Patch (straight) cable
Side 1
Pin Wire color
1 White-orange
2 Orange
RJ-45
3 White-green
connector
4 Blue
5 White-blue
6 Green
7 White-brown
8 Brown
Crossover cable
Side 1
Pin Wire color
1 White-orange
Twisted
2 Orange
Pairs
3 White-green
4 Blue
5 White-blue
6 Green
7 White-brown
8 Brown
• Subnet mask
Side 2
Pin Wire color
1 White-orange
2 Orange
3 White-green
4 Blue
5 White-blue
6 Green
7 White-brown
8 Brown
Side 2
Pin Wire color
1 White-green
2 Green
3 White-orange
4 Blue
5 White-blue
6 Orange
7 White-brown
8 Brown
255.255.0.0