Remote Control; Selected Sis Commands; Establishing A Network (Ethernet) Connection - Extron electronics DMS 1600 Setup Manual

Remote Control

This section describes using the remote control features of the
DMS matrix switchers to control the devices. Topics that are covered
include:
•

Selected SIS Commands

•
Installing and Starting the Control Program
•
Accessing the HTML Pages
Selected SIS Commands
You can use Simple Instruction Set (SIS) commands for operation and
configuration of the switchers. You can run these commands from a PC
connected to a serial port (
or USB port (

Establishing a Network (Ethernet) Connection

NOTE:
you may need to change the default settings (IP address, subnet
mask, and [optional] administrator password) of the switcher.
Establish a network connection as follows:
1. Open a TCP socket to port 23 using the IP address of the switcher.
The switcher responds with a copyright message including the
name, firmware version, and part number of the product, and the
current date and time.
2.
If necessary, enter the appropriate password.
If the password is accepted, the switcher responds with Login User
or Login Administrator .
If the password is not accepted, the Password prompt reappears.
1
on page 9) on the switcher.
The first time you connect to the switcher via the LAN port,
NOTE: The factory default IP address is 192.168.254.254.
NOTES:
•
If the switcher is not password-protected, the device is
now ready to accept SIS commands.
•
If the switcher is password-protected, a password prompt
appears.
•
The factory configured passwords for all accounts on this
device have been set to the device serial number. In the
event of a complete system reset, the passwords convert
to the default, which is no password.
DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Remote Control
5
on page 8), Ethernet port (
6
on page 8),
11