Multi-Color Embroidery - Pfaff creative 1472 Instruction Book

Embroidery stitch
programs
Multi-colour embroidery
Thesemulti colourembroiderypossibilitiessetno
limits to your imagination. Carried out with great
devotion to detail, colour and decorative etfects,
multicolour embroidery gives your clothes the
stamp of your personality
The following pages are intended as an inspira
tion for ornamentation of dresses, blouses and
other garments with embroidery motifs made on
your Pfaff Creative.
Transfer the pattern onto the face side of the
fabric with tracing paper
Always place two sheets of tissue paper under the
material before you start sewing.
prog
-
f
(1j
L
06 62 65 77
j
—3+
2A
H
Sewing thread: Embroidery or darning thread
Motif 1 is made up of the patterns enumerated
above.
First workstep: stems
• Program 06
• Change the stitch length to 25 mm.
• Follow the traced hnes with a program 06
seam.
Second workstep: leaves
• Program 62
• Change the stitch width to 4.0 mm.
• Change the pattern length to 25
• Push the "single pattern" key.
• Needle in down position.
• Sew the leaf slightly curved, starting at the
stem. Leave the needle down
in
the fabric, turn
the fabric through 180° and sew the pattern
backwards In this way, all leaves can be sewn
larger or smaller.
Third workstep: half flower
• Program 65
• Stitch width 5.0 mm.
• Pattern length: 20
• Push the "single pattern" key.
• The tio of the pattern should contact the stem.
Fourth workstep: flowers
• Program: 62
• Stitch width: 4.5 mm
• Pattern length: 20.
• Push the "single pattern" key
• Sew the petals, including those of the half
flower
Fifth workstep: flower centre (dot>
• Programm 77
• Stitch width: 50mm
• Push the "single pattern" key.
• Sew the flower centres (dots>.
First workstep: centre motif
• Select program 64.
• Sew the programmed stitch pattern.
First workstep: centre motif
• Select program 50.
• Sew the programmed stitch pattern.
Second workstep:
• Select program 65 and change zigzag width to
4-5 mm.
• Sew the programmed stitch pattern along
both sides of the centre motif
Third workstep: side motifs
• Enter program 87.
• Sew the programmed stitch pattern on both
sides along the previously sewn motif.
105
°,
ER
ER
ER
ER
F
Border 1 consists of the following programs:
Centre motif: 64
Side motif: 39
Second workstep: side motifs
• Select program 39.
• Sew the programmed stitch pattern along
both sides of the centre motif. The second side
motif can be sewn without turning the fabric by
pushing the "pattern mirror" key.
Border 2 consists of the following programs
506587