Cleaning And Oiling; Inserting The Needle Plate; Changing The Light Bulb; Changing The Fuse - Pfaff creative 1472 Instruction Book

Changing the fuse
S Disconnect the mains plug Turn fuse
holder A left by a quarter turn with a
screwdriver, release it and take it out,
Pull out fuse B Insert a new fuse in the
holder, replace the holder, push it in
with the screwdriver, then turn it right
E
by a quarter turn. (The fuse type is
F2A.) 110-volt machines have no fuse.
Changing the batteries:
Switch on the machine, so that the
memories are not lost when the batte
ries are changed, and tilt the machine
over backwards. A battery compart
ment is installed in the base. Lift cover
B at the catches in recesses A and
remove cover Take out the batteries.
Insert the new batteries with the plus
side (+) facing upwards:
Place cover B in so that hinges C
engage in recesses 0 and press cover
j
until it snaps in place
After changing the batteries, check the
contents of the memories.
Replacement batteries:
2 Mignon cells, 1.5 V, type LR 6
-
,
Only use leak-proof batteries!
s;.,..
:
7-
E3
Cleaning and oiling
• Pull out the mains
plug.
Tilt the needle plate up at the back (A)
and remove it (B). Clean the teed dog
and the parts in the sewing hook area
with a soft brush Clean the bobbin
thread monitor as instructed on page
157. Apply a drop of oil in the hook
receway, as shown in the illustration.
every 15 lo 20 hours of operation.
Other than that, the machine is main
tenance-free and must not he oiled.
Inserting the needle plate
Place the needle plate on with its left
side first and press it in until the retai
ning hook snaps in audibly. Then
press the right side firmly down until it
also snaps in, Check the correct posi
tion of the needle plate.
Changing the light bulb:
• Disconnect the mains plug.
Swing out the work support to the
left. Close the hinged top cover and
swing up the carrying handle. Insert
the edge guide into cutout D, push
down the lamp housing and hold it
there. Push the bulb upwards, turn it
towards A and take it out. Insert the
new bulb so that its pins enter slots C
Push it up and turn it towards B Pull
out the edge guide. Be sure to use
only a 15-watt light bulb in the sewing
lamp.
42
4