Pfaff creative 1472 Instruction Book page 245

Cause:
Remedy:
5. Machine feeds irregularly or not at all
Lint has accumulated between tooth
Remove needle plate and remove lint with
rows of feed dog.
a soft brush.
Feed dog lowered. (Slide control is at
Push slide control to the left.
right).
6. Machine runs with difficulty
Thread ends in hook raceway.
Remove thread ends and put one drop of
oil into hook raceway.
7. Electronic bobbin thread monitor does not work
Thread ends and dirt have collected in Remove thread ends and dirt. Special care
the free arm cover over the sensor, in should be taken in the area round the
the hook raceway, in the bobbin case,
second sensor.
behind the hook and on the second sen
sor to the right behind the hook.
8. Machine does not sew the program entered
Switch the machine off, wait about 30 seconds, then switch it on again. Again enter the
desired program.
9. Machine can no longer be programmed
If you find that it is not possible to program the computer although it is not filled
up, the machine must be switched off. Press key 47 "Correction B/L" after about 30
seconds, hold it down and switch the machine on again by actuating main switch
9. Release button 47.
By means of this procedure the contents of both the M- and P-memory has been fully
erased. Required program sequences and patterns must be entered once more.
10. The sewing lamp lights up, but the machine does not run
Fuse is defective.
Insert new iuse.
Important:
Before exchanging either sewing foot or needle, switch off master switch 9.
Never run a threaded machine unless there is a piece of fabric under the sewing foot.
If you have to leave the machine, even for a short while, be sure to switch off the master
switch. This is particularly important when children are around.
.4 7