Pfaff creative 1472 Instruction Book page 123

Cleaning and oiling
• Pull out the mains plug.
Tilt the needle plate up at the back (A)
and remove it (B). Clean the feed dog
and the parts in the sewing hook area
with a soft brush. Clean the bobbin
thread monitor as instructe d on page
157. Apply a drop of oil in the hook
receway , as shown in the illustrati on,
every 15 to 20 hours of operatio n.
Other than that, the machine is main
tenance- free and must not be oiled.
Inserting the needle plate
Place the needle plate on with its left
side first and press it in until the retai
ning hook snaps in audibly. Then
press the right side firmly down until it
also snaps in. Check the correct posi
tion of the needle plate.
-I
Changin g the light bulb:
• Disconn ect the mains plug.
Swing out the work support to the
left. Close the hinged top cover and
swing up the carrying handle. Insert
the edge guide into cutout D, push
down the lamp housing and hold it
there. Push the bulb upwards , turn it
towards A and take it out. Insert the
new bulb so that its pins enter slots C.
Push it up and turn it towards B. Pull
out the edge guide. Be sure to use
only a 15-watt light bulb in the sewing
lamp.