Table of Contents
Advertisement
effect becomes active.
Parameter 2 Atk
Parameter 3 Peak (Ratio)
Determines the compression ratio for signals
exceeding the threshold. Higher values result in
higher compression ratio.
Parameter 4 Tone
Type 4 DUAL COMP (Dual Compressor)
This effect allows choosing a different compression
value for the low range and high range.
Parameter 1 Sens1
Determines the compressor depth for the high range.
Parameter 2 Sens2
Determines the compressor depth for the low range.
Parameter 3 X-F
Determines the frequency for dividing the high range
and low range.
Parameter 4 Bal
Determines the level balance of high range and low
range.
Type 5 DEFRET
This effect simulates the slow-attack sound of a
fretless bass. The effect should be used only when
playing single notes.
DIST/AMP (Distortion/Amp Simulator)
This module comprises distortion effects such as overdrive and fuzz. It also includes amp simulator
settings for duplicating the sound of bass guitar amplifiers.
TYPE
1. CLN1
DIST/AMP
Parameter 1
Parameter 2
Parameter 3
Parameter 4
Parameter 5
Parameter 6
Effect types
The following eight effect types are available in the
DIST/AMP module.
Type 1 CLN1 (Clean 1)
Type 2 CLN2 (Clean 2)
ADVANCED BASS EFFECTS PROCESSOR
2. CLN2
3. TE–C
4. SW–C
( RTM)
Mid Enh
1–30
oF, C0–C9, S0–S9
1: DIST-WAH 2: WAH-DIST
DIST/AMP RTM
Parameter 1 Sens
Determines the input sensitivity.
Parameter 2 Atk
Determines the attack speed.
Type 6 SLAP
This effect simulates the slap playing style with
sharp attacks. The effect should be used only when
playing single notes.
Parameter 1 Sens
Parameter 2 Atk
Higher values result in emphasized attack.
Common parameters for Type 1 - 6
Parameter 5 Level
Determines the module output level.
Parameter 6 Volume RTM (P)
This is a patch parameter which determines whether
the patch level is controlled by RTM. The input level
of patches for which this parameter is set to ON can
be controlled with the FUNCTION switch or remote
pedal RP01.
For controlling Volume RTM with the FUNCTION
NOTE
switch on the 3000B, the FUNCTION Mode
Parameter (page 22) must be set to "9: RTM".
5. OD
6. FUZZ
( RTM)
Gain
1–30
Level
0–30
D. Level
0–30
Cabinet
1, 2
oF, 1–30
Type 3 TE-C (TE-Clean)
Type 4 SW-C (SW-Clean)
Type 5 OD (Overdrive)
Type 6 FUZZ
Type 7 FN-D (FN-Drive)
Type 8 AC-D (AC-Drive)
7. FN–D
8. AC–D
41
Advertisement
Table of Contents
