Operation Differences Of Manual Mode And Program Mode - Zoom GFX-4 Operation Manual

• Unlike other modules, the EQUALIZER module
has only one effect type. Therefore pressing
the TYPE DOWN/UP keys has no effect. (The
display shows only EQUALIZER "HIGH".)
• When a module that is currently set to off is
selected, the effect type and parameter cannot
be changed.
For the effect types PDLWAH (pedal wah) and
PDLPIT (pedal pitch) in the MODULATION
module only, it is possible to directly call up the
editing display by pressing the PEDAL
WAH/PEDAL PITCH key. For details, see page
26.
5.
To set the effect parameters of the selected
module, operate parameter knobs 1 - 3 of the
corresponding FX panel.
The display shows the most recently edited parameter
name, and the GROUP/BANK indicator shows the value
of the parameter.
Lit when parameter was changed

Operation Differences of Manual Mode and Program Mode

When the MANUAL key is pressed while the GFX-4 is in
program mode, the unit switches to manual mode.
(Pressing the key again switches back to program mode.)
In manual mode, the foot switches 1 - 3 on the FX panels
serve to turn modules on and off. This lets you change the
sound of the currently selected patch in a way similar to
using a compact effect.
Module LED
Module LED of last edited module flashes
and display shows parameter name/effect
Display
type name. GROUP/BANK indicator
GROUP/BANK
shows parameter value.
indicator
Foot switches
Switch respective module on and off
1 - 3
To activate
Press BANK L switch
bypass (mute)
mode
6.
7.
Parameter name
Operation differences in manual mode and program mode
are listed below.
Manual mode
You can also use the
select the effect type and alter the parameter
value. The / keys serve to bring up the effect
type or parameter 1 - 3, and the L/M keys serve
to adjust the value.
Use the module keys to select another module
and adjust the effect type/parameter value and
on/off setting in the same way.
When editing is completed, store the patch as
required.
If you call up another patch in program mode
without storing the current patch, any editing
changes will be lost.
Program mode
Module LED indication of last edited
module, display and GROUP/BANK
indicator function are the same as in
program mode, but display reverts to
program mode initial display after about 5
seconds.
Switch patches
Press foot switch of currently selected patch
number (LED lit)
keys and L/M keys to
/
17
ZOOM GFX-4