Ac Power Adaptor Installtion (For Surefi Re System) - Regency P36E-NG4 Owners & Installation Manual

AC Power Adaptor Installation (For Surefi re System)
An optional AC power adaptor may be installed as a constant power source for the SureFire system.
This will avoid battery leakage and power drainage. 4-AA Battery pack may be re-installed into receiver during power outages.
NOTE: For all Gas Fireplaces 120 volt power must be brought to the receptacle box inside the
All Freestanding Gas Stoves & Gas Inserts will need a receptacle box located outside / near the unit
INSTALL AC ADAPTOR WITH SUREFIRE WALL SWITCH ONLY - (WITHOUT REMOTE)
1) Locate "DC Supply" tag on wire harness. For location in unit
see remote installation page in owners manual.
INSTALL AC ADAPTOR WITH SUREFIRE PROFLAME GT / GTM REMOTE
This method also applies for models, HZ30E - HZ40E - L390E - HZI390E
1) Connect the male end of the AC adaptor to the female end of the
wire adaptor (supplied with AC adaptor) together as shown .
Wire adaptor
2) Locate FCM - COM connector on the Remote wire harness -
see manual for location in unit.
FCM - COM
P36E-4 Zero Clearance Direct Vent Gas Fireplace
NOTE: AC power adaptor is not required when using GTMF Remote
IMPORTANT: Recommend removing the 4-AA batteries in the SureFire receiver.
so that the AC Power Adaptor can be plugged in.
AC adaptor
2) Connect the male end from AC adaptor to the female end
tagged "DC Supply" on wiring harness in unit.
3) Plug AC adaptor into 120V wall outlet (or into 120V receptacle if
4) Neatly tuck any loose AC Power Adaptor wires neatly underneath /
inside the appliance.
Note:
(keep wires away from the heat as much as possible).
3) Plug in wire adaptor to FCM - COM connector - be careful not
AC adaptor
wire adaptor
4) Plug AC adaptor into 120V wall outlet (or into 120V receptacle if
5) Neatly tuck any loose AC Power Adaptor wires neatly underneath /
inside the appliance.
Note:
(keep wires away from the heat as much as possible).
(provided with the unit).
FCM - COM
49