Table of Contents
Advertisement
installation
|
45
AC POWER ADAPTOR INSTALLATION (FOR SUREFIRE SYSTEMS)
AC POWER ADAPTOR INSTALLATION (FOR SUREFIRE SYSTEMS)
An AC power adaptor is supplied with this appliance and may be installed as a constant power source for the SureFire system.
NOTE: AC power adaptor is not required when using GTMF Remote with fan control module and must be disconnected.
IMPORTANT: Recommend removing the 4-AA batteries in the SureFire receiver.
This will avoid battery leakage and power drainage. 4-AA Battery pack may be re-installed into receiver during power outages.
1. Plug AC adaptor into a 120V wall outlet or into the 120V
receptacle if installed inside the gas fireplace.
2. Tuck any loose wires neatly underneath the firebox–inside
the fireplace.
Note: Ensure that wires do not touch the underside of the fire
box (Keep wires away from heat as much as possible).
AC adaptor
Wire adaptor
|
45
Regency® P33E-10 Zero Clearance Direct Vent Gas Fireplace
1
10/09/14
919-063
Advertisement
Table of Contents
