Check Ignition Of Surface Burners - GE P2B918 Owner's Manual & Installation Instructions

|
€
°.
i
|
4
m
|
.!
i
|
|
L
(
|
C
|
€
€
€
-!
i
€
1
€
|
(,
L
(
1
i
|
(
£
Installation of the range.
[] Seal the Openings
Seal any openings in the wall behind the range and
in the floor under the range when hookups are
completed.
[] Assemble Surface Burners
[] Burner Heads (on some models)
Place burner heads over the electrodes
on the cooktop, in the correct locations
according to their size.There is one small, one
medium, one large and one extra large burner
head.
Front of range head
Hake sure the slot
in the burner head
is positioned over _:._ u_}
the electrode._
Electrode._ "_'Slot
[] Oval (Center) Burner Head/Cap Assemblg
Place the oval (center) head/cap assemblg
over the electrode on the cooktop.
Oval head and cap
assemblg
• ®
Front of range
Make sure the slot in
the burner head is
positioned over the
electrode.
Electrode
[] Caps
Place the matching size caps onto the burner
bases or heads.
Front of range cap
Make sure that the heads and caps are
replaced in the correct locations.
[] Grates
Place the left, right and center grates on the
cooktop. These grates are position specific.
The undersides of the left and right grates
are marked "LEFTFRONT"and "RIGHTERONT_'
Place the middle grate with its bowed front
toward the front of the range.
Left Front Center Right Front
CAUTION:
not operate the burner
without all burner ports in place.
50
[] Check Ignition of Surface Burners
Operation of all cooktop burners should be checked
after the range and gas supplg lines have been
carefullg checked for leaks.
Electric Ignition
Select a top burner knob and simultaneouslg
push in and turn to LITE position.You will hear
a clicking sound indicating proper operation of
the spark module. Oncethe air has been purged
from the supplg lines, burners should light within
4 seconds. After burner lights, rotate knob out of
the LITE position. Trg each bumer in succession
until all burners have been checked.