GE P2B918 Owner's Manual & Installation Instructions page 47

Read these instructions completely and carefullg.
[] Replace the Power Cord (Optional) Continued
Perform this step onlg if the power cord shipped on the range does not match gout wall
receptacle.
[] 3-Wire Power Cord Installation Option
[]
[]
[]
[]
[]
[]
WARNING: The neutral or g round
wire of the power cord must be connected to
the neutral terminal located in the center of the
terminal block. Thepower leads must be
connected to the lower left and the lower right
terminals of the terminal block.
Locate the copper ground strap on the lower
back of the range.
Loosen the upper center screw on the terminal
block.
Slidethe open slotted end of the ground strap
under the upper center screw on the terminal
block. Make sure the ground strap is all the
wag against the upper center screw and
tighten it in place.
Placethe ground plate (removed earlier) over
the bottom of the ground strap, press them
against the range frame and attach them
with the ground screw (removed earlier).
Insert the new power cord through the strain
relief. Allow enough slackto easilg attach the
wires to the terminal block.
Insert the 3 terminal screws (removed earlier)
through each power cord terminal ring and
into the lower terminals of the terminal block.
Be certain that the center wire (white/neutral)
is connected to the center lower position of
the terminal block.Tighten screws securelg
(approximatelg 20 inch-lbs.)into the terminal
block.
Ground
plate -
Ground strap
Terminal block
(appearance
mag varg)
Neutral
Ground strap
'_ O_ Open slotted end
[] Secure the strain relief in place in the bracket
bg tightening the strain relief screws.
47