Installation Instructions - GE P2B918 Owner's Manual & Installation Instructions

Installation of the range.
Read these instructions completely and carefully.
IN THE COMMONWEALTH OF MASSACHUSETTS
;;J_:, This product must be installed by a licensed
plumber or gas fitter.
?_ When using ball tgpe gas shut-off valves, theg
shall be the T-handle tgpe.
?_ A flexible gas connector, when used, must not
exceed 3 feet.
BEFORE YOU BEGIN
Installation of this range must conform with local codes, or in the absence of local codes,
with the National Fuel Gas Code, ANSI Z223.J_/NFPA.54, latest edition. This range has been
design-certified bg CSA International according to ANSI Z2J_.J_, latest edition.
As with ang appliance using gas and generating
heat, there are certain safetg precautions gou should
follow. You will find these precautions in the Important
Safety Information section in the front of this manual.
Read them carefullg.
IMPORTANT: OBSERVE ALL GOVERNING CODES
AND ORDINANCES.
NOTE: This appliance must 8e properly grounded.
IMPORTANT: S avethese instructions for the local
electrical inspector's use.
NOTETOINSTALLER: L eavethese instructions with the
appliance after installation is completed.
NOTETOCONSUMER: K eepthis Owner's Manual and
Installation Instructions for future use.
SERVICER: The electricaldiagram is in an envelope
attached to the back of the range.
FOR YOUR SAFETY
Do not store or use combustible materials, gasoline or other flammable vapors and liquids in the
vicinity of this or ong other appliance.
If you smell gas:
[] Open windows.
[] Don't touch electrical switches.
[] Extinguish ang open flame.
[] Immediatelg call gour gas supplier.
ELECTRICAL REQUIREMENTS
II, CAUTION:FOR PERSONAL SAFE
DO NOTUSEAN EXTENSION CORDWITHTHIS
APPLIANCE. REMOVE HOUSE FUSEOROPEN
CIRCUIT BREAKER BEFORE BEGINNING
INSTALLATION.
This appliance must be supplied with the proper
voltage and frequencg, and connected to an
individual, properlg grounded circuit, protected
bg a circuit breaker or time-delag fuse, as noted
on the rating plate.
Wiring must conform to National ElectricalCodes.
If the electric service provided does not meet the
above specifications, have a licensed electrician install
an approved outlet.
Because range terminals are not accessible after
range is in position, flexible service conduit or cord
must be used.
39