GE P2B918 Owner's Manual & Installation Instructions page 49

Read these instructions completely and carefullg.
[] Replace the Power Cord (Optional) Continued
Perform this step only if the power cord shipped on the range does not match gout wall
receptacle.
[] 4-Wire Conduit Installation Option
[] Removethe strain relief clamp from the
bracket.
[]
Assemble the squeeze connector (obtained
locally),matching the diameter of your
conduit, in the bracket hole. Insert the conduit
through the squeeze connectoE Allow enough
slack to easily attach the wires to the terminal
block.
[]
NOTE:Do not install the conduit without a
squeeze connector:
Insert the ground bare wire tip between the
range frame and the ground plate (removed
earlier) and secure it in place with the ground
screw (removed earlier).Insert the bare wire
(white/neutral) tip through the bottom center
of the terminal block opening. Insert the two
side bare wire tips into the lower left and the
lower right terminal block openings. Tighten
the screws until the wire isfirmly secure
(approximately 20 inch-lbs.).
NOTE:Hake sure the wire is completely
inserted into the terminal block and a secure
connection is made.
[] Secure the squeeze connector in place in the
bracket by tightening the squeeze connector
screws.
NOTE: ALUMINUM WIRING:
Aluminum building wire may be used but it must be
rated for the correct amperage and voltage to
make connection.
Squeeze
connector
Conduit
Bracket
Terminal Ground
plate
(grounding
to range}
Wire ti \
screw /' __
Bracket
Wire used, location and enclosure
of splices, etc., must conform to good wiring
practices and local codes.
[] Replace the Wire Cover
Replacethe wire cover on the range back by sliding
its right edge under the retaining tab and replacing
the two screws removed earlieEHake sure that no
wires are pinched between the cover and the range
back.
2 screws ,
to replace
wire cover
Back of range
49