Check Ignition Of Surface Burners - GE P2B918 Owner's Manual And Installation Instructions

Installation of the range.
[_ Seal the Openings
Seal any openings in the wall behind the range and
in the floor under the range when hookups are
completed.
[_ Assemble Surface Burners
[] Burner Heads (on some models)
Place burner heads over the electrodes
on the cooktop, in the correct locations
according to their size.There is one small, one
medium, one large and one extra large burner
head.
Hedium head ® Small head
L g "_ _'_ Extra large
Front of range head
Hake sure the slot
in the burner head
is positioned over _}
the electrode._
Electrode_ "_'Slot
[_ Oval (Centefl Burner Head/Cap Assemblg
Placethe oval (center) head/cap assemblg
over the electrode on the cooktop.
Oval head and cap
assemblg
• ®
Front of range
Hake sure the slot in
the burner head is
positioned over the
electrode.
Electrode
_] Caps
Placethe matching size caps onto the burner
bases or heads.
Hed,.._m_cap I I Sma_llcap
L _ _ e
Front of range cap
Hake sure that the heads and caps are
replaced in the correct locations.
Grates
Placethe left, right and center grates on the
cooktop. These grates are position specific.
The undersides of the left and right grates
are marked "LEFTFRONT" and "RIGHTFRONT."
Placethe middle grate with its bowed front
toward the front of the range.
Left Front Center Right Front
^,4,
CAUTION: o
not operate the burner
without al! burner parts in place.
50
[_ Check Ignition of Surface Burners
Operation of all cooktop burners should be checked
after the range and gas supplg lines have been
carefullg checked for leaks.
Electric Ignition
Select a top burner knob and simultaneouslg
push in and turn to LITE position. You will hear
a clicking sound indicating proper operation of
the spark module. Once the air has been purged
from the supplg lines, burners should light within
4 seconds. After burner lights, rotate knob out of
the Life position. Trg each burner in succession
until all burners have been checked.