Clock And Timer - GE P2B918 Owner's Manual & Installation Instructions

Usingthe clock and timer.
Not all features are on all models.
<ii
_i_!i _#i_i_,_ i I IL _i_i /
Make sure the clock is set to the
correct time of dog.
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of day
cannot be changed during a timed baking or
self-cleaning cycle.
[] Touch the Clock pad.
[] Touch the number pads.
If number pads are not touched within one
minute after you touch the Clock pad, the
display reverts to the original setting. If this
happens, touch the Clock pad and reenter
the time of day.
[] Touch the Start pad until the time
of day shows in the display. This enters
the time and starts the clock.
Touch the number pads the same way you
read them. For example, to set 12:38, touch
the number pads 1, 2, 3 and 4 in that ordeE
To checkthe time of day when the display is
showing other information, simply touch the
Clockpad. Thetime of dabl shows until
another pad is touched.
KITCHEN TIMER J
ON/OFF
DDND
The timer is o minute timer only.
The Cleor/Off pod does not affect
the timer.
To Set the Timer
Thetimer does not control oven operations.
Themaximum setting on the timer is 9 hours
and 59 minutes.
[]
[]
Touch the Kitchen Timer On/OFFpad.
Touch the number pads until the
amount of time you want shows in
the display. The maximum number
of minutes that can be entered is 59.
To set additional time, you will need
to set it by hours and minutes.
For example, to enter I hour and
30 minutes, touch 1, 3andO in
that order
tf _lou make a mistake, press the Kitchen
Timer On/OFF pad and begin again.
[] Touch the Start pad. After pressing
the Start pad, SETdisappears; this tells
you the time is counting down, although
the display does not change until one
minute has passed.
[] When the timer reaches :00, the control
will beep 3 times followed by one beep
every 6 seconds until the Kitchen Timer
On/Off pad is touched.
The 6 second tone can be canceled bbl
following the steps in the Specialfeatures
Ofblour oven control section under Tones
at the End of a Timed Cycle.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by touching
the Kitchen Timer On/OFFpad; then touch
the number pads until the time you want
appears in the display.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
touching the Kitchen Timer On/OFF pad and
then touching the number pads to enter the
new time you want.
To Cancel the Timer
Touch the Kitchen Timer On/OFFpad twice.
Power Outage
If a flashing time is in the display, you have
experienceda power failure. Resetthe clock.
To reset the clock, touch the Clock pad.
Enter the correct time of day by touching
the appropriate number pads. Touch the
Start
pad.
16