Epson EMP-7950 User Manual page 62

Preventing theft (Password Protect)
Turn "User's Logo Protect" on.
4
(1) Select "User's Logo Protect", and then press the [Enter]
button on the remote control or the [Auto/Enter] button on
the projector's control panel.
(2) Select "ON", and then press the [Enter] button on the
remote control or the [Auto/Enter] button on the
projector's control panel.
(3) Press the [ESC] button on either the remote control or the
projector's control panel.
Enter the password.
5
(1) To set a password, select "Password" and then press the
[Enter] button on the remote control or the [Auto/Enter]
button on the projector's control panel.
(2) The message "Change the password?" will be displayed,
so select "Yes" and then press the [Enter] button on the
remote control or the [Auto/Enter] button on the
projector's control panel.
The default setting for the password is "0000", but you
should change this to your own desired password.
If you select "No", the screen shown at step 1 will be
displayed again.
(3) Enables numeric keypad of the remote control and enter a
4-digit password.
The password entered will be displayed as "****".
Once four digits have been entered, the confirmation
screen will be displayed.
(4) Re-enter the password.
The message "The new password is stored." will be
displayed.
If you enter the password incorrectly, a message will be
displayed prompting you to re-enter the password.
Once the setting is complete, press the [Menu]
6
button.
Press the [Num] button on the remote control to
cancel numeric keypad mode.
Check that the [Num] button indicator is turned off.
TIP
• When the set time has elapsed and the password is entered,
projection will start and the "Timer-elapsed" counter will be cleared
to count again.
• Make a note of the password so that you do not forget it and keep it
in a safe place.
• If you lose the remote control, you will not be able to enter the
password. Keep the remote control in a safe place at all times.
User's Guide
61