Turning The Projector Off - Epson EMP-7950 User Manual

Turning the Projector Off

Follow the procedure below to turn the projector off.
PROCEDURE
Turn the power off for the signal sources that are
1
connected to the projector.
Check that the power for all connected components has been
turned off.
Press the [Power] button on either the remote control
2
or the projector's control panel.
Remote control
The following confirmation message will appear.
Power OFF?
Yes : Press button
No : Press any other button
If you do not want to turn the power off, press a button other
than any of the following:
• At the remote control: [Power], [ ], [ ], [ ], [Num], [ID]
• At the control panel : [Power]
If you do not press any button, the message will disappear
automatically after seven seconds. (The power will not turn off
at this time.)
TIP
If the message "The projector is overheating. Make sure nothing is
blocking the air vent, and clean or replace the air filter." appears on
the screen, press the [Enter] button on the remote control or the
[Auto/Enter] button on the projector's control panel to turn the power
off and then clean the air filters.
Press the [Power] button on either the remote control
3
or the projector's control panel once more.
The lamp will switch off. The
cool-downg will start.
The cool-down period lasts for about 20 seconds.
When cool-down is complete, the
TIP
• The remote control and projector's control panel buttons cannot be
operated while the indicator is flashing orange. Wait until it lights
constantly.
• If "Standby Mode" in the configuration menu is set to "Network
ON", fans will continue operating. This is normal and does not
indicate a problem.
User's Guide
p.140
indicator will flash orange and
indicator lights orange.
Stops flashing and lights orange
40