Turning the Projector On
Turning the Power On and Projecting Images
TIP
• If Password Protect has been enabled, the Password Protect Release
screen will be displayed when the power is turned on.
Type in the password.
p.58
• If the "Advanced2" - "Operation Lock" menu setting is set to
"ON", none of the buttons on the projector's control panel will work
except for the [Power] button.
Use the remote control buttons at such times.
PROCEDURE
Check that the
indicator has stopped flashing and
1
is lit orange.
If using the remote control, set the [R/C] switch on the
2
remote control to "ON".
Turn the power on for all equipment connected to the
3
projector.
For a video source, press the [Play] button at the video source to
start playback if necessary.
p.76
Press the [Power] button on either the remote control
4
or the projector's control panel to turn the power on
for the projector.
The
indicator flashes green. After a short period it stops
flashing and lights steadily, and projection starts.
Wait until the
indicator lights green (it normally takes about
30 seconds to change).
Remote control
TIP
• The remote control and projector's control panel buttons will not
function while the
indicator is flashing green.
• Depending on the configuration menu settings, the message "No
Signal." may appear. See "Setting" - "No-Signal Msg."
User's Guide
36
Changes from flashing to lit green
p.86