Epson EMP-7950 User Manual page 105

Monitoring and Controlling Projectors via a Network (for the EMP-7900)
Connection of the projector will start, and the following
3
Setup for Network Projector window will be displayed.
If "DHCP" is set to "OFF", the settings for the "Network"
function in the "Advanced2" menu will be displayed. Make any
changes that are necessary.
The projector name can consist of up to 15 single-byte
alphanumeric characters. Hyphens(-) also can be used. Note
that a numeric-only name can not be set.
Once the network settings for the projector have been
4
completed, click [Mail Notification Setting] and make
the settings for mail notification such as the
notification destinations.
The following Setup of mailing functions window will
5
be displayed.
The following table shows the setting details for each item.
Mail Set to "ON" to use the mail notification function.
Notification
function
IP addressg of Specify an IP address of the SMTP server.
You can enter numbers from 0 to 255 in each field of the
SMTP server
IP address. However, the following IP address cannot be
used.
127.x.x.x, 224.0.0.0 to 255.255.255.255
(where x is a number between 0-255)
When you change a port number of the SMTP server,
specify this port number. The default value is "25".
You can enter a valid number from 1 to 65535.
Destination Specify the destination address of the notification mail.
Up to three destinations can be set. You can enter up to
address
53 single-byte alphanumeric characters.
1/2/3
The address you have set as "Destination address 1" is
also used as the source address.
Setting a Use this to select the events that cause a mail notification
to be sent when a problem or warning occurs with the
Notification
projector.
Event
You can select one or more of the following.
• Internal error
• Lamp timer failure
open
• Internal temperature error
• High-speed cooling in progress
• Lamp replacement notification
User's Guide
104
• Fan related error. • Sensor error
• Lamp out • Lamp cover is
•No-signal