Epson EMP-7950 User Manual page 130

Problem Solving
The projector cannot be monitored and controlled using the EMP Monitor function
Check
Is the wireless or wired LAN card inserted?
For the EMP-7950
Is the network cable connected correctly?
When using the EMP-7950
connected to a wired LAN, or
when using the EMP-7900
Are the settings for connecting to a network
correct ?
Has EMP Monitor function been correctly
installed to the computer?
Have all projectors that are to be monitored
and controlled been registered in the
projector list?
Has "Standby Mode" been set to "Network
ON"?
Is power being supplied to the projector?
Check that the wireless LAN card is correctly inserted into the card slot of the projector.
"Inserting and Removing Cards"
Check that the network cable is connected correctly. If it is not connected or is connected
incorrectly, reconnect it.
Check the network settings for the projector.
If using the EMP-7950 "Connecting in Access Point Mode or Wired LAN Mode" in the EasyMP
Network Setup Guide
If using the EMP-7900 p.101
Uninstall EMP Monitor and then re-install it.
If using the EMP-7950 "If You would like to Uninstall the EasyMP Software" and "Installing
EasyMP Software" in the EasyMP Network Setup Guide
If using the EMP-7900 p.99, p.100
Register the projector in the projector list.
If using the EMP Monitor function while the projector is in standby mode, change the "Standby
Mode" menu setting to "Network ON".
Check if the power supply to the location where the projector is set up has been interrupted, or if the
circuit breaker for the electrical outlet that the projector is connected to has been tripped.
Remedy
p.17
p.108
"Advanced1" - "Standby Mode"
User's Guide
129
p.91