HP StorageWorks P9000 Manual page 53

Table 8 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKG2x) (continued)
Message ID Message Text
YKH205W TSO This copygroup does not
support LinkageOption=HS.
SUPFNC=SUPFnc
YKJ000E TSO Unable to execute without
RC=48 valid name parameter.
YKJ001E TSO name parameter is too long.
RC=48
YKJ002E TSO The specified PREFIX is
RC=48 being used by another
program.
Explanation and Recommended Actions
Cnt Ac-S Z with the HyperSwap attribute cannot be used in this
storage system because 2DC configuration with HyperSwap and
Cnt Ac-J Z is not supported. Use a device
configuration with HyperSwap and Cnt Ac-J Z can be used. Also,
if scanning was not performed after the storage system microcode
was updated, perform a scan.
SUPFnc (hexadecimal number)
Value for the version (minimum value) of the
storage system support function used in the copy
group
#
The following lists the type of storage system for which you can
use 2DC configuration with HyperSwap and Cnt Ac-J Z:
XP24000 Disk Array
P9500 Disk Array
Nothing or an invalid value is assigned to the parameter identified
by name.
name
Parameter name
The parameter identified by name is too long.
name
Parameter name
The specified prefix is being used by another program.
Check the value specified for the prefix.
#
in which 2DC
List of Messages 53