HP StorageWorks P9000 Manual page 163

Table 42 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKZ29x) (continued)
Message ID
YKZ296E MSG SC=44
RC=44
Message Text
A JNLG is not registered in EXCTG.
(JNLG=jj, MIRROR=m, EXCTG=e,
SN=ssssssssssss)
Explanation and Recommended Actions
The journal group is not registered in EXCTG.
The journal group registration to EXCTG might have
failed because the YKMAKE command has not been
executed on the copy group container with EXCTG
ID specified, or an error occurred during the
execution of the YKMAKE command. Alternatively,
the journal group might have been removed from
EXCTG because the YKRECVER command has been
executed on the copy group container with EXCTG
ID specified.
Remove the cause of the problem if the YKZ297E
message is output during the execution of the
YKEWAIT or YKQUERY command after executing the
YKMAKE command on the copy group container with
EXCTG ID specified. Then execute the YKMAKE
command again with a SELECT(COND) specification
to register the journal group to EXCTG.
Note that, to register an existing journal group in
EXCTG, you need to execute the YKQUERY command
before executing the YKMAKE command with a
SELECT(COND) specified. In this case, the YKZ296E
message will appear until the registration has
completed normally.
Also, if you execute the YKQUERY command to obtain
the status while the copy pair of the copy group
containers with EXCTG ID specified is dissolved, the
YKZ296E message sometimes appears when the
dissolving of the copy pair is detected at a different
time from the dissolving of EXCTG, but this does not
mean that an error has occurred. In this case, wait
until the copy pair status changes to SIMPLEX, and
then re-execute the YKQUERY command. The message
will no longer appear.
List of Messages 163