Send Faxes; Send An Outgoing Fax; Examples Of Typical Faxes; Job 1: One Original - Lexmark X443 User Manual

Send faxes

Send an outgoing fax

There are two ways to send an outgoing fax using the keypad on the control
panel.
Enter a fax recipient number
1
Place your original document in the scan unit.
2
Press Fax Mode on the control panel repeatedly until you see
in the display.
3
Enter the telephone number of the person receiving the fax.
4
Press Go/Send. The fax modem dials the number and sends the fax once
the connection is made. Press Stop/Clear to cancel sending a fax.
Use a fax destination shortcut
1
Place your original document in the scan unit.
2
Press #, and then enter the shortcut number of fax destination on the
control panel numeric keypad.
3
Press Go/Send. The fax modem dials the number and sends the fax once
the connection is made.
Note: When you cancel a fax, the control panel resets to copy mode.

Examples of typical faxes

The following examples illustrate how to send a fax using the OptraImage
control panel and the scan unit.

Job 1: one original

1
Place your original in the scan unit.
2
Press Fax/Scan Mode repeatedly until
3
Enter the fax recipient phone number on the numeric keypad.
4
Press Go/Send.
appears in the display.
Enter Number
46
When entering the phone
number, press Pause to insert
a three second delay during
dialing.
Enter Number
When you cancel a fax, the
control panel resets to copy
mode. You must restart the fax
sending process.
Press Stop/Clear to cancel
sending a fax.
Each of the examples assumes
the basic fax configuration
(date, time, station name and
number) has been done.