Using The Marknet Print Server In Germany; Using The Marknet Print Server In Switzerland; Using The Marknet Print Server In Norway And Spain - Lexmark X443 User Manual

Using the MarkNet print server in Germany

The MarkNet print server requires a German billing tone filter (P/N 14B5123) to be
installed on any line which receives metering pulses in German.
The subscriber may request that metering pulses be placed on the line, or can have them
removed by calling the German network provider. Normally, metering pulses are not
provided unless specifically requested by the subscriber at the time of installation.
Note:
Metering pulses may or may not be present on analog lines in Germany.

Using the MarkNet print server in Switzerland

The MarkNet print server requires a Switzerland billing tone filter (P/N 14B5109) to be
installed on any line which receives metering pulses in Switzerland.
Note:
Metering pulses are present on all analog telephone lines in Switzerland.

Using the MarkNet print server in Norway and Spain

The MarkNet print server complies with all the standard DC voltage requirements as
specified in the EU standards document CTR 21.
However, the MarkNet print server does not meet the more unusual requirements for
maximum voltage in the loop state, as specified in EG 201 121 V1.1.1 advisory note
NO 02 for Norway and advisory note ES 01 for Spain. In the unlikely event of low loop
current, the DC voltage may exceed the 7.4 Volt maximum.
If this occurs, the user may experience problems with the Central Office recognizing an
off-hook condition. This condition could occur in the event that the subscriber is at the
end of very long telephone lines which are attached to older Central Office equipment.
105