Setting Up System Parameters (Menu 7) - Ericsson RX1290 Reference Manual

Step
6
7
8
9
10
11
12
3.11

Setting Up System Parameters (Menu 7)

This menu gives access to the Set-up Menu to set-up and edit System Parameters
as well as the Multi-Format Receiver Details menu (see Table 3.42).
Table 3.41 Setting Up a System
Step
1
2
3
4
5
EN/LZT 790 0003/2 R1A
Action
Scroll to Menu 6.4 and edit the
AUDIO 2 menu (NO ALARM,
SET ALARM ONLY). Press Save.
Scroll to Menu 6.5 and edit the
AUDIO 3 menu (NO ALARM,
SET ALARM ONLY). Press Save.
Scroll to Menu 6.6 and edit the
AUDIO 4 menu (NO ALARM,
SET ALARM ONLY). Press Save.
Scroll to Menu 6.7 and edit the
MER menu (NO ALARM, SET
ALARM ONLY). Press Save.
Scroll to Menu 6.8 and edit the
BER menu (NO ALARM, SET
ALARM ONLY). Press Save.
Scroll to Menu 6.9 and edit the
EBNO menu (NO ALARM, SET
ALARM ONLY). Press Save.
Scroll to Menu 6.10 and edit the
TEMPERATURE menu (NO
ALARM, SET ALARM ONLY).
Press Save.
Action
Go to Menu 7.
Scroll to Menu 7.1 and edit the
Operating Mode (FRONT PANEL,
SERIAL REMOTE, NCP or NETWORK
(SNMP). Press Save.
Scroll to Menu 7.1.1 and edit the LCD
Contrast (LOW, MEDIUM or HIGH).
Press Save.
Scroll to Menu 7.1.2 and edit the
SERIAL REMOTE PROTOCOL mode
(RS232 ALTEIA or RS485 ALTEIA).
Scroll to Menu 7.1.3 and edit the IP
Address. Press Save.
Operating the Equipment Locally
Result
Edits the Audio 2 alarms menu.
Edits the Audio 3 alarms menu.
Edits the Audio 4 alarms menu.
Edits the MER Error Rate (00.0 to 69.9) and
status menu.
Edits the BER Error Rate (00.0 to 69.9) and
status menu.
Edits the EBNO
Edits the Temperature menu.
Result
Accesses the System menu.
Edits the Operating Mode menu.
Edits the LCD Contrast.
Select the interface needed for serial
remote control.
Edits the IP Address.
3-27