Multi-Format Receiver Details Menu - Ericsson RX1290 Reference Manual

Menus
Display Title: Setup
XXXXXXXXXXXXX
LCD Contrast XXXXXX
Serial Remote Protocol
XXXXXXXXXXXXXXXXXXXXX
IP Address
XXX.XXX.XXX.XXX
Subnet Mask
XXX.XXX.XXX.XXX
Gateway Address
XXX.XXX.XXX.XXX
Syslog Address
XXX.XXX.XXX
Restore System Defaults
Service Hunt Mode
XXXXXXXX
SI Mode
XXX
Customization Key
XXXXXXXXXXXXXXXXXXXXXX
C.10.2

Multi-Format Receiver Details Menu

The Multi-Format Receiver Details submenu displays the software, firmware,
hardware, PLD version and electronic serial number of the CR.
Table C.38 CR Details Menu
Display Title: CR Details
Electronic Serial Number
XXXXX
Software Version
C-24
Description
FRONT PANEL
SERIAL REMOTE (not supported in software version
1.0.0)
NETWORK (SNMP)
XXXXXX is editable in the range:
LOW
MEDIUM
HIGH
XXXXXXXXXXXXXXXXXXXXX is editable:
RS-232 TTV, RS-232 ALTEIA AT ADDR YYY, RS-485
ALTEIA AT ADDR YYY where YYY is CR address
from 000 to 999.
XXX.XXX.XXX.XXX is the editable IP address
XXX.XXX.XXX.XXX is the editable subnet mask
XXX.XXX.XXX.XXX is the editable Gateway address
XXX.XXX.XXX is the editable Syslog address.
Restores system defaults.
XXXXXXXX is the editable parameter for setting
automatic service selection (ENABLED, DISABLED)
XXX is the editable parameter for SI detection (AUTO,
ATSC, DVB)
XXXXXXXXXXXXXXXXXXXXXX is the editable
parameter for entering customization keys
Description
XXXXX is the unit serial number
XX.XX.XX is the software version number
EN/LZT 790 0003/2 R1A