10/100Baset Input - Rx1290/Hwo/Ip - Ericsson RX1290 Reference Manual

Operating the Equipment Locally
3.6.3 10/100BaseT Input – RX1290/HWO/IP
Table 3.8 steps through the set-up procedure of the Telco Receiver using
Menu 2 Input, and the IP input.
Table 3.8 Setting Up the IP Interface
Step
1
2
3
4
5
6
7
8
3-12
Action
Connect the Ethernet cable to
the IP input connector.
Power up the unit and
navigate to Menu 2 Input.
Navigate to UDP PORT (Menu
2.3.2), then press Edit.
Select the Receive UDP Port
number, then press Save.
Navigate to IP INPUT IP
ADDRESS (Menu 2.3.2.1),
then press Edit.
Select the IP address, then
press Save.
Navigate to IP INPUT
SUBNET MASK (Menu
2.3.2.2), then press Edit.
Select the Subnet mask, then
press Save.
Navigate to IP INPUT
GATEWAY ADDRESS (Menu
2.3.2.3), then press Edit.
Select the Gateway address,
then press Save.
Navigate to IP INPUT
MULTICAST IP ADD (Menu
2.3.2.4), then press Edit.
Select the Multicast IP
address, then press Save.
Return to Input Menu 2, it
should display the current
status. If status is NOT
LOCKED, verify that the cable
is properly connected and that
all values have been entered
correctly.
Result
Accesses the Input menu.
Edits the UDP Port parameter.
Edits the IP Input address parameter.
Edits the IP Input subnet mask parameter.
Edits the IP Input Gateway address parameter.
Edits the IP Input Multicast IP address parameter.
EN/LZT 790 0003/2 R1A