10/100Baset Ip Input Option Menu - Ericsson RX1290 Reference Manual

Table C.6 TTV G.703 Menu
Display Title: Input
STATUS
PDH Rate
XXXXX
RANDOMISATION XXXX
STUFFING PKTS YYYY
SETUP
REED-SOLOMON DECODER
XXXXX
INTERLEAVER
XXX
INPUT SENSITIVITY
XXXX
C.5.5

10/100BaseT IP Input Option Menu

When a 10/100BaseT input interface is used, the Input menu allows the user to edit
the set-up parameters
Table C.7 IP Input Menu
Display title: Input
STATUS
Last IP Received From
XXXX.XXXX.XXXX.XXXX
Encapsulation Mode
YYYY
XXXX
SETUP
UDP PORT NUMBER
XXXXX
IP ADDRESS
XXXX.XXXX.XXXX.XXXX
NETWORK MASK
XXXX.XXXX.XXXX.XXXX
DEFAULT GATEWAY
XXXX.XXXX.XXXX.XXXX
MULTICAST IP ADDRESS
XXXX.XXXX.XXXX.XXXX
EN/LZT 790 0003/2 R1A
Description
XXXXX is the framing mode of the TTV G.703 input module (None, C-Bit,
M13)
XXXX (ACTIVE, NOT ACTIVE)
YYYY (PRESENT, NOT PRESENT)
XXXXX is the EDITABLE Reed-Solomon option. (DISABLED, ENABLED)
XXX.X is the EDITABLE Interleaver option (DISABLED, ENABLED)
XXXX is the EDITABLE Signal Level option (NORMAL, LOW)
Description
XXXX.XXXX.XXXX.XXXX is the IP address the last MPEG-2 packet was
received from.
YYYY (UDP ONLY, RTP ONLY, RTP FEC MODE)
XXXX status (NO DATA, LINK DOWN, OUT OF REGULATION)
XXXXX shows the EDITABLE UDP Port Number on which the IP Input
Card is listening for packets.
XXXX.XXXX.XXXX.XXXX is the EDITABLE IP address of the IP input
card.
XXXX.XXXX.XXXX.XXXX is the EDITABLE subnet mask of the IP input
card.
XXXX.XXXX.XXXX.XXXX is the EDITABLE gateway address of the IP
input card.
XXXX.XXXX.XXXX.XXXX is the EDITABLE multicast IP address of the IP
input card.
Menus
C-9