Table of Contents
Advertisement
Available languages
Available languages
Changing the Clock
The Select Functions
Menu
_
Change the Beep Volume
Change the Temperature
Scale
Turn Clock Display ON or
OFF
_)_
Access Demo Mode
Getting Started
Note: If operation is not completed, the oven will beep periodically as a reminder
to set clock time. Press OFF.
1.
Press Time. TIMER 1 flashes in display.
2.
Turn knob to select CLOCK.
3.
Press Time and hour digits flash.
4.
Turn knob to change hours.
5.
Press Time again and minute digits flash.
6.
Turn knob to change minutes.
7.
Press Time again and the clock is set.
Note: To cancel the TIME selection when setting the clock, press OFF at any time
while in the clock mode.
SELECT FUNCTIONS is the section of the menu where you can set or change
the range features listed below.
To access the SELECT FUNCTION menu
1.
Press and hold BAKE pad for five (5) seconds. SELECT FUNCTION is dis-
played.
2.
Turn knob slowly to desired feature. There will be a slight delay before each
message (or feature) can be seen in the display. Turn knob slowly and wait
approximately one second for display to show next feature.
3.
Press START to choose the function.
4.
Turn knob to desired setting and press START.
When all settings for the function are complete, SELECT FUNCTION flashes
again.
5.
Press OFF to exit the Select Functions Menu.
The volume of the control beep can be changed from LOW (softest) to HIGH
(loudest). The control default for beep volume is Medium.
1.
Access SELECT FUNCTIONS Menu.
2.
Turn knob clockwise until VOLUME is displayed.
3.
Press Start.
4.
Turn knob to select volume level Low, Medium or High.
5.
Press Start.
The oven has been preset to the Fahrenheit temperature scale. The feature
allows you to switch between Fahrenheit and Celsius temperature.
1.
Access SELECT FUNCTIONS Menu.
2.
Turn knob clockwise until SELECT TEMP F-C is displayed.
3.
Press Start.
4.
Turn knob to select Fahrenheit (F) or Celsius (C).
5.
Press Start to accept new selection.
Clock time display can be turned off. The default display is on.
1.
Access SELECT FUNCTIONS Menu.
2.
Turn knob clockwise until CLOCK DISPLAY is displayed.
3.
Press START.
4.
Turn knob to select ON or OFF
5.
Press START to accept new selection.
The demo mode is for appliance store use only.
English 9
Advertisement
Chapters
Table of Contents
