Dell 3115 Color Laser User Manual page 524

nvert file.txt to the ript language program and output it to the file.ps file, type as
follows:
% txt2ps2 file.txt > file.ps
% lpr file.ps Linux)
% lp (for Solaris/HP-UX)
To c output result of the command into the PostScript language program xt2ps2 and print it
to the multifunction printer, type as follows:
% ls -alF | txt2ps2 | lpr (for Linux)
% ls -alF | txt2ps2 | lp (for Solaris/HP-UX)
Environmental Variable
TXT2PS2OPTION
Optional settings based on the environmental variable. To outp -up mode, 8 points and the
landscape orientation, type as follows
% setenv TXT2PS2OPTION "-2 -s8 -r"
To use the same options as tho e dellpsif filter specified by printcap, type as follows:
nv TXT2PS2OPTION "<dellpsif>"
File
/usr/local/dellbin3115/.dellpsdefault3115
This is the default command option setting file for al users.
Important
When the same option is specified twice, the later setting wi As TXT2PS2OPTION is an
fore the option of the command line, it is possible to temporarily m e options already
set in TXT2PS2OPTION by typing at the command line.
The comment description (%%page:m n) of the page number cannot be outp PostScript
program file which is output by the default option of t hus, when the output of
txt2ps2 is to be taken as the output of anot ication (psrev of TRANSCRIPT add the
page number description by inserting the line command (-Ilines).
If a BS code is found at the beginning of a line, the print p f the next character will be
located at the left of the beginning of ne.
When there are multiple tab codes in one line, t tion may be off as a result of automatic
line feed. In such case, -I or -w option.
The number of columns speci the -w option is not the ac er of printed characters. The
actual number of single-byte character printed is derived by deducting the output
column position (outco fied by the o option from the number of columns specified by