Dell 3115 Color Laser User Manual page 169


Do not mix print media sizes, weights, or types i ame source. This may result in a
paper jam.

Do not remove trays while a job is or Printing is displayed o erator panel.

re the Paper Type settin ct. (See
these settings.)

Ensure the paper is properly loaded tray.

Flex paper back and forth, en fan them. Straighten the edges of the stack on a level
surface.
Selecting Preprinted Forms and Lett
When selecting preprinted forms and d paper for the multifunction printer:

Use grain long papers for best results.

Use only forms and letterhead printed using an offs graphic or engraved printing
process.

Select papers that absorb ink, but do not blee

Avoid papers with rough or heavily surfaces.

Use papers printed w -resistant inks designed for use in xerographic copiers. The ink
must nd temperatures of 225°C (437°F) without melting or releas dous emissions.

Use inks ot affected by the resin in toner or the silicone in the fuser uni that are
oxidation-set or oil-based should meet these requirements; ks might not. If you are
in doubt, contact your paper supplier.
Pri Letterhead
Check with the manufacturer or ve determine whether the pre-printed letterhead you have
selected is ac for laser printers.
Page orientation is important when printing on ld. Use the following table for help when
loading letterhead in the p a sources.
Print media source
"Tray Settings(See 13.)" f led information about
side e orientation