Configuring Modbus Tcp/Ip Options - Eaton Power Xpert Gateway Series 1000 Card User Manual

Configuring Modbus TCP/IP Options

To limit access to the card from trusted Modbus TCP/IP addresses only:
1.
2.
3.
NOTE When using host names, verify that the IP address of your network DNS Server is
configured (see "Network Configuration" on page 16).
NOTE If the SMTP server does not use Port 25, append the port to the IP address (for
example, mysmtpserver:33).
4.
For information on Modbus registers, see Chapter 5, "Modbus
Registers," on page 49.
EATON Power Xpert
From the card's Web page, click the Access Control link from the
menu bar.
Activate the check box for Modbus-TCP access restricted by
IP/hostname.
Type the trusted host's IP addresses or host names, separated by a
semi-colon, in the Trusted IPs/hostnames field.
Click Apply and then OK to save the settings.
® Gateway Series 1000 Card User's Guide
CONFIGURING THE CARD
S 25
164201670 Rev 1