Verifying Ip Addresses (Dhcp Enabled) - Eaton Power Xpert Gateway Series 1000 Card User Manual

Verifying IP Addresses (DHCP Enabled)

To verify the IP address assignments:
1.
2.
3.
4.
5.
6.
7.
8.
* If the IP address field contains [None], press Enter to return to the Network Settings menu and wait 60 seconds.
Repeat Steps 1 through 8. If the field remains [None], contact your local network administrator to verify that the
DHCP server is responding to requests.
EATON Power Xpert
Type 1 and press Enter on the Network Settings menu (see Figure 7
on page 7) to display the Network Settings: Ethernet Port 1 menu
(see Figure 8).
---------------------------------------------------------
------ Network Settings: Ethernet Port 1 ------
---------------------------------------------------------
1. Dynamic Addressing (DHCP) Enabled
2. IP Address
3. Subnet Mask
4. Default Gateway
MAC Address
Link Status
0. Exit to previous menu
Select an option ==>
Figure 8. Ethernet Port 1 Menu
Verify and record the IP address for Port 1*.
Type 0 and press Enter to return to the Network Settings menu.
If you connected Ethernet Port 2 to a separate network, continue to
Step 5 to verify the assigned IP address. Otherwise, continue to
Step 8.
Type 2 and press Enter on the Network Settings menu to display the
Network Settings: Ethernet Port 2 menu.
Verify and record the IP address for Port 2*.
Type 0 and press Enter to return to the Network Settings menu.
Type 0 and press Enter to exit the utility.
® Gateway Series 1000 Card User's Guide
GETTING STARTED
10.222.51.250
255.255.255.0
10.222.51.254
00:60:26:10:89:A8
Enabled
S
164201670 Rev 1
9