Network Configuration - Eaton Power Xpert Gateway Series 1000 Card User Manual

GETTING STARTED

Network Configuration

If you know the card's IP address, you can configure the network
settings from the card's Web page:
1.
2.
3.
4.
16
EATON Power Xpert
Open a Web browser, type the IP address of the card, and select
Go.
The login prompt appears. The user name and default password is
user for read-only information and admin for configuration
(read/write) options. Log in as admin.
The PXGX Series 1000 Card Web page opens (see Figure 18).
Enter the Card's IP Address
Figure 18. PXGX Series 1000 Card Web Page
Select the Network link from the menu bar.
The Network Configuration Settings page appears. The page shows
the current network status for each port on the card (green
indicates the network is connected; red indicates the network is
disconnected).
You can enable or disable the DHCP control by activating or
deactivating the check box. The default is DHCP enabled.
® Gateway Series 1000 Card User's Guide
S
164201670 Rev 1