Pneumatic Step 15 - Cycle Data
Navigate to the Cycle Data tab.
Begin a weld cycle using the cycle activation switches.
•
Inspect the weld results of your finished part on the
Cycle Data page.
•
Review weld data to insure the process was done as
programmed.
•
Values for the completed cycle should be displayed
under each programmed parameter.
Figure 4-40 below shows the top and bottom parts of the
Cycle Data page. Because all of the parameters will not
fit on one page, move the scroll bar (right and/or left) at
the bottom to view the entire set of weld parameters.
Dukane iQ Explorer - [Welder 1- Setup 4]
iQ Explorer, Cycle Data Page
Figure 4-40
Dukane Manual Part No. 403-575-00
Use the scroll bar at the bottom of the
Cycle Data screen to display all of the
parameters.The bar moves the screen
image right and left because a typical
display will not show the entire set of
parameters at once.
Scroll Bar
Section 4 - Operation
NOTE
Parameters
Page 69