Dukane iQ Series User Manual page 72

iQ Series
Ultrasonic Generator/Power Supply ES User's Manual
Pneumatic Step 12 - Process Settings >Secondary Control
Secondary controls provide additional ways to end the
weld portion of a cycle together with the primary control
method specified.
This means control of the weld process can be accom-
plished either by the primary control or by one or more
secondary controls.
Secondary control is not typically needed for basic setup.
See Figure 4-37 below.
Figure 4-37 iQ Explorer, Process Settings > Secondary Control
Pneumatic Step 13 - Test the Acoustic Stack
Run a test of the acoustic stack.
Please go to Section 5 of this User's Manual, System Op-
erational Testing, where the system test procedures are
outlined.
Page 66
Dukane Manual Part No. 403-575-00