Hitachi CP-X10000 User Manual page 62

Item
SERVICE COMMUNICATION
(continued)
DAISY CHAIN: Select this type, if it is required to
connect multiple projectors using a shared RS-232C
communication bus, from the computer. (
Guide - 3.8 Multi-controlling the plural projectors (using
DAISY CHAIN function))
OFF: Select this mode if you want to output no data
from the CONTROL OUT
NOTE
• When you select the NETWORK BRIDGE, check
the item, TRANSMISSTION METHOD.
SERIAL IN SETTING/SERIAL OUT SETTING
In these menus, you can select
the communication condition for
each of the CONTROL IN
CONTROL OUT ports. CONTROL OUT
BAUD RATE
4800 bps
38400 bps
(continued)
PARITY
NONE
TRANSMISSION METHOD
This menu is available only when the NETWORK
BRIDGE is selected for the COMMUNICATION TYPE.
Select the transmission method for communication by
the NETWORK BRIDGE from the CONTROL OUT
HALF-DUPLEX
HALF-DUPLEX: This method lets the projector make
two way communication, but only one direction, either
transmitting or receiving data, is allowed at a time.
FULL-DUPLEX: This method lets the projector make
two way communication, transmitting and receiving
data at the same time.
NOTE
setting.
• When you select HALF-DUPLEX, check the items,
RESPONSE LIMIT TIME and BYTES INTERVAL TIMEOUT.
Description
CONTROL OUT port.
• OFF is selected as the default setting.
CONTROL IN and
9600 bps
19200 bps
ODD EVEN
FULL-DUPLEX
• HALF-DUPLEX is selected as the default
OPTION menu
Network
CONTROL OUT port.
53