Hitachi CP-X10000 User Manual page 54

Item
MESSAGE
SOURCE NAME
(continued on next page)
Using the / buttons turns on/off the message function.
ON OFF
When the ON is selected, the following message function works.
"AUTO IN PROGRESS" while automatically adjusting
"NO INPUT IS DETECTED"
"SYNC IS OUT OF RANGE"
"INVALID SCAN FREQ"
"Searching...." while searching for the input
"Detecting...." while an input signal is detected
The indication of the input signal displayed by changing
The indication of the aspect ratio displayed by changing
The indication of the PICTURE MODE displayed by changing
The indication of the ACTIVE IRIS displayed by changing
The indication of the MY MEMORY displayed by changing
The indication of "FREEZE" and "II" while freezing the screen by
pressing the FREEZE FREEZE button.
• When the OFF is selected, please remember if the picture is
frozen. Do not mistake freezing for a malfunction (
Each input port for this projector can have a name applied to it.
(1) Use the / buttons on the SCREEN menu to
select SOURCE NAME and press the
The SOURCE NAME menu will be displayed.
(2) Use the / buttons on the SOURCE
NAME menu to select the port to be named
and press the button. Right side of the
menu is blank until a name is specifi ed.
The SOURCE NAME dialog will be displayed.
(3) The current name will be displayed on
the fi rst line. Use the
and the ENTER ENTER or VIDEO VIDEO button to select and
enter characters. The RESET
used to erase 1 character at a time. Also if you
move the cursor to DELETE or ALL CLEAR on
screen and push the ENTER
1 character or all characters will be erased. The
name can be a maximum of 16 characters.
(4) To change an already inserted character,
press the button to move the cursor to the
fi rst line, and use the
the cursor on the character to be changed.
After pressing the ENTER ENTER or VIDEO
character is selected. Then, follow the same
procedure as described at the item (3) above.
(5) To fi nish entering text, move the cursor to the
OK on screen and press the ENTER
previous name without saving changes, move the cursor to the CANCEL on
screen and press the ENTER
Description
button.
/ / / buttons
RESET button can be
ENTER or VIDEO VIDEO button,
/ buttons to move
VIDEO button, the
ENTER or VIDEO VIDEO button. To revert to the
ENTER or VIDEO VIDEO button.
SCREEN menu
25).
45