Using The Remote Id Function; Using As A Wired Remote Control; Laser Pointer - Hitachi CP-X10000 User Manual

Remote control

Using the REMOTE ID function

This is the function to defi ne which projector is controlled by the remote control. Utilize
this function when you use some projectors of the same type at the same time.
Set the ID number to the projector beforehand,
1.
referring to the item "REMOTE ID" item (
Press a ID button on the remote control. The ID button
2.
selected will light for 3 seconds.
NOTE • Each time you press any button (except ID buttons), the ID button of
current selected ID number will light.
• To confi rm the projector's current ID, press any ID button for 3 seconds. Its
number will be shown on each screen regardless of set ID of projector.

Using as a wired remote control

The accessory remote control works as a wired remote control,
when the wired control port at the bottom of the remote control
connects with the REMOTE CONTROL REMOTE CONTROL port on the back of the
projector via an audio cable with 3.5 diameter stereo mini plugs.
This function is useful when a wireless remote signal
may not reliably reach the projector.
NOTE • To connect the remote control with the projector, use an audio cable
with 3.5 diameter stereo mini plugs.

Laser pointer

This remote control has a laser pointer in place of a fi nger or rod. The laser beam
works and the LASER INDICATOR LASER INDICATOR lights while the LASER
WARNING
on the screen. Do not apply the laser beam to anything except the screen.
• Never hit eyes by the laser beam since the laser beam can injure eyes.
• Do not apply the laser beam to anything except the screen.
18
Use the laser beam of the remote control only for the pointer
52).
MI
LASER button is pressed.
Laser aperture
LASER INDICATOR LASER INDICATOR
ID 1 ID 3
ID 2 ID 4
MONITOR
DVI-D
OUT
CONTROL IN CONTROL OUT REMOTE
S-VIDEO
CONTROL
IN
COMPUTER
OUT
VIDEO 1 BNC
R/Cr/Pr G/Y B/Cb/Pb H
Y
Cb/Pb
Cr/Pr
LASER button LASER
VIDEO
DIGITAL