Fitting The Frame Components - DURKOPP ADLER 171 Operating Manual

Set-up
Operating manual 171/173 Version 01.0 - 01/2016
6.3

Fitting the frame components

Fig. 33: Fitting the frame components
②
⑤
(1) - Head sections
(2) - Oil can holder
(3) - Frame bars
(4) - Cross bars
1. Screw the cross bars (4) onto the frame bars (3).
2. Screw the cross strut (7) onto the foot struts (6).
3. Screw the head sections (1) onto the frame bars (3).
4. Push all 4 frame feet (5) onto the foot struts (6).
5. Loosen all 8 fastening screws (8) on the cross struts (4)
slightly and ensure that the machine is standing securely.
Important: The frame must sit evenly on the ground with
all 4 feet.
6. Tighten all 8 fastening screws (8).
7. Screw the oil can holder (2) at the rear to the upper
cross bar (4).
①
③
④
⑥
⑧
(5) - Frame feet
(6) - Foot struts
(7) - Cross strut
(8) - Fastening screws
⑧
⑤
⑦
55