Removing The Transport Locks; Assembling Frame Components - DURKOPP ADLER 878-M PREMIUM Operating Instructions Manual

54

7.2 Removing the transport locks

All transport securing devices must be removed prior to setup.
1. Remove the lashing straps and wooden blocks from the
machine head, the table, and the frame.
2. Remove the support wedges between the machine arm and
throat plate.

7.3 Assembling frame components

Fig. 31: Assembling frame components
8
2
7
(1) - Upper sections of the inner bars
(2) - Inner bars
(3) - Frame bars
(4) - Cross bar
1. Screw the cross bar (4) onto the frame bars (3).
2. Screw the oil can holder (8) at the rear to the upper cross
bar (4).
3. Screw the cross strut (6) to the foot struts (5).
4. Insert the inner bars (2) in such a way that the longer end of
the head section (1) is above the longer end of the foot struts
(5).
5. Screw the inner bars (2) down so that both head sections (1)
are at the same height.
Important: Turn the adjusting screw (7) so that the frame has
even contact with the ground.
Operating Instructions 878-M PREMIUM - 02.0 - 02/2018
1
4
6
4
3
5
(5) - Frame foot struts
(6) - Cross strut
(7) - Adjusting screw
(8) - Oil can holder
1
2
3
5
Setup