Operation; Automatic Sewing Sequence - Duerkopp Adler 506 Operating Instructions Manual

Hide thumbs Also See for 506:

Table of Contents

2. Operation

ATTENTION !

Before commissioning it is essential that the number of stitches per

curve disk revolution be set at the internal DIP switch (b500) of the

controls appropriate to the curve disk used (see Part 4: Short

Description Multicontrol).

The starting of a sewing sequence is only possible with the head cover

and cover 3 for the hook area closed.

If the head cover or cover for the hook area is open all functions of the

controls are blocked.

Work procedure (in foot switch mode 1)

–

Turn on the motor protection switch 1 under the table top.

It normally remains turned on constantly.

–

Turn the main switch 2 on.

The clamps are in their upper position.

–

Select sewing program.

–

Align the sewing material under the clamps.

Depending on the type of work sequence this can occur according

to the markings or the stops mounted specifically for the customer.

Caution Risk of Injury !

Keep hands free of the lowering clamps.

–

Operate the right foot switch 5.

Both clamps lower simultaniously.

–

Check the correct alignment of the sewing material.

To correct the sewing material alignment operate the right foot

switch again.

Both clamps rise.

–

Operate the left foot switch 4.

The automatic sewing sequence starts.

Table of Contents