Fujitsu Siemens Computers pmn User Manual page 498

Message lines
Depending on the Primergy type the server will be reactivated after the wait time specified
in the BIOS setup and the system started up. This mechanism is governed by the "ASR&R
Boot Delay" and "Boot Retry Counter" entries in the BIOS setup.
Response
Notify maintenance staff.
SXSM006 sma#: *** SHUTDOWN *** (Shutdown temperature = <value> degrees Celsius at sensor
<Id>)
ALERT
SXSM006 sma#: *** SHUTDOWN *** (Shutdown because of critical temperature)
ALERT
Meaning
The critical temperature of a sensor has reached the shutdown threshold value. The SINIX
system is shut down and the server deactivated.
Depending on the Primergy type the server will be reactivated after the wait time specified
in the BIOS setup and the system started up. This mechanism is governed by the "ASR&R
Boot Delay" and "Boot Retry Counter" entries in the BIOS setup.
A defective temperature sensor
Response
Notify maintenance staff.
SXSM009 sma#: Critical temperature = <value> degrees Celsius at sensor <Id>
ALERT
Meaning
The temperature of sensor <Id> is in the critical range. If a further temperature increase
exceeds a predefined limit value, a controlled shutdown will be initiated by the monitoring
software and the server deactivated.
A defective temperature sensor
Response
Notify maintenance staff.
1
On the Primergy F250 the temperature sensors have the following meanings:
Sensor 0: CPU 0 temperature
Sensor 1: Inside temperature
Sensor 2: CPU 1 temperature
Sensor 3: Auxiliary = ambient temperature
498
1
can also trigger this message.
1
can also trigger this message.
Explanation of console messages
U41117-J-Z125-7-76